How to Remove Airsoft Aug Backplate

Wiki

Attach | Edit | Revisions
Related Content

How To Disassemble the AUG Airsoft Rifle

The #Steyr #AUG is manufactured in #Australia and is used by #armed forces #forces all over the world. Being a bullpup, the longer barrel in a shorter overall length provides numerous advantages in airsoft. This article shows you lot how to disassemble the AUG airsoft burglarize.

Comments & Word >>

Removing the Quad-Track

We are going to illustrate the disassembly process with the JG UA-three RAS AEG. That is because the JG UA-3 RAS is a Steyr AUG A2/A3 variant with the quad-rail upwards front. Information technology has i additional disassembly step compare to the A1 version. That actress step is the removal of the quad-rail.

Cantankerous-Reference
We accept a review article for the JG UA-3 RAS. You can read almost it here: "JG Urban Attack UA-3 RAS Airsoft Electronic Gun Review".

There are 2 hex screws on the top front end portion of the Picatinny rail (see photo below). Unscrew these two hex screws.

Then push the quad forward and remove information technology (see photo below).

From this point frontward, the reset of the disassembly process applies to all airsoft AUG AEG's.

Comments & Discussion >>

Detaching the External Barrel

To disassemble the external barrel, y'all need to pull the charging handle back first (see photo beneath).

After pulling the charging handle back, yous can unlock the external barrel. The unlocking mechanism is the knob on the left side in the photo below.

Once the external butt is unlocked, pull the external barrel forward to remove it from the gun (see photo below).

Comments & Discussion >>

Separating the Receiver

The receiver can be separated. To do so, yous accept to slide the safety switch completely out of the gun. Once you lot've washed that, pull the receiver apart (see photo below).

Comments & Discussion >>

Removing the Gearbox

The gearbox is in the shoulder stock. To remove the gearbox, yous have to go through the battery compartment. In that location is a comprehend that is fastened by 2 modest screws (see photo below). Remove the two screws and remove the cover.

After removing the cover, you can slide the version 3 gearbox out (encounter photograph below).

Comments & Word >>

Taking Autonomously the Magazine

A Phillips screw (encounter photo below) on the lesser of the magazine, shut to the winding cycle, allows you to take information technology autonomously.

Once you unscrew the Phillips screw, you tin slide the bottom plate off the magazine. And so y'all tin push the magazine insert upward and remove it from the top of the magazine (run across photo below).